Home » Control and Load Switches » 10-25 Ampere » screw terminal

 

» Mountings

Basically the CA-series are designed for vertical wiring. Horizontal wiring is available for Panel Mounting and Base Mounting.

Basically the CG-, CH-series are designed for horizontal wiring. Vertical wiring is available for Panel Mounting and Base Mounting.

Panel Mounting

The Panel Mountings are well used mountings which cover wide application ranges.
They consist of two main groups.

• The two/four hole mountings, which are fixed by (2/4) screws
  around the center shaft hole.
• While at the single-hole mountings the shaft hole is used for fixation.

The two/four hole mountings provide several variations which make them fit for all tasks.

Base Mounting

Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distributing cabinets.
The switch can be mounted at the base panel by two or four screws and also by 'Snap-On'. For this mounting, several door clutches with or without padlock are available.

 

Contact  l  Terms of Delivery  l  Imprint  l  Data protection